Commercial Service Tools

Engine Lubrication System

Other materials:

Power supply and ground circuit
A/C auto AMP. : Diagnosis Procedure 1.CHECK SYMPTOM Check symptom (A or B). Which symptom is detected? A >>GO TO 2. B >>GO TO 5. 2.CHECK FUSE 1. Turn ignition switch OFF. 2. Check 10A fuse (No. 3, located in fuse block (J/B)]. NOTE: Refer to PG-22, "Fuse, Connector ...

P1820 engine speed signal
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...

Fuel level sensor signal circuit
Component Function Check 2WD MODELS 1.CHECK COMBINATION METER OUTPUT SIGNAL Select the “Data Monitor” for the “METER/M&A” and compare the “FUEL METER” monitor value with the fuel gauge reading on the combination meter. Does monitor value match fuel gauge reading? YES >> INSPECTIO ...