Precaution

Precautions for Trouble Diagnosis CAUTION: • Never apply 7.0 V or more to the measurement terminal. • Use a tester with open terminal voltage of 7.0 V or less. • Turn the ignition switch OFF and d ...

System

Can communication system CAN COMMUNICATION SYSTEM : System Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex commun ...

Other materials:

C1115 wheel sensor
DTC Logic DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT-III. 1. Stat the en ...

BCM (body control module)
Removal and Installation CAUTION: Before replacing BCM, perform “READ CONFIGURATION” to save or print current vehicle specification. Refer to BCS-150, "Description". REMOVAL (RHD MODELS) 1. Remove glove box assembly. Refer to IP-13, "Removal and Installation". 2. Remove ...

Fuel pressure check
Work Procedure FUEL PRESSURE RELEASE 1.FUEL PRESSURE RELEASE With CONSULT-III 1. Turn ignition switch ON. 2. Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode with CONSULT-III. 3. Start engine. 4. After engine stalls, crank it two or three times to release all fuel pressure. 5. Turn i ...