Commercial Service Tools

...

Component parts

CVT control system : Component Parts Location 1. Multi display unit (MDU)* Refer to DMS-3, "Component Parts Location". 2. Combination meter 3. S mode indicator (On the combination met ...

Other materials:

Additional service when replacing ECM
Description When replacing ECM, this procedure must be performed. Work Procedure 1.PERFORM INITIALIZATION OF NATS SYSTEM AND REGISTRATION OF ALL NATS IGNITION KEY IDS Refer to SEC-50, "ECM : Work Procedure". >> GO TO 2. 2.PERFORM ACCELERATOR PEDAL RELEASED POSITION LEARNIN ...

B2628 outside antenna
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Disconnect outside key antenna (rear bumper) connector. 2. Perform “INTELLIGENT KEY” Self Diagnostic Result. Is outside key antenna DTC detected? YES >> Refer to DLK-240, "Diagn ...

B2098 ignition relay on stuck
Description • IPDM E/R operates the ignition relay when it receives an ignition switch ON signal from BCM via CAN communication. • Turn the ignition relay OFF by pressing the push-button ignition switch once when the vehicle speed is 4 km/ h (2.5 MPH) or less. • Turn the ignition relay ...