Nissan Juke Service and Repair Manual : Special Service Tools

Commercial Service Tools


    Other materials:

    C1164, C1165 CV system
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT ...

    Assembly and Installation
    • Use torque wrench to tighten bolts or nuts to specification. • When tightening nuts and bolts, as a basic rule, equally tighten in several different steps starting with the ones in center, then ones on inside and outside diagonally in this order. If the order of tightening is specified, do ...

    Rear disc brake
    Brake pad : Exploded View 1. Sliding pin bolt 2. Cylinder body 3. Inner shim cover 4. Inner shim 5. Inner pad (with pad wear sensor) 6. Pad retainer 7. Torque member 8. Outer pad 9. Outer shim 10. Outer shim cover 1 Apply rubber grease. 2: Apply MOLYKOTE® AS880N or silicone-bas ...