Nissan Juke Service and Repair Manual : Special Service Tool

Periodic maintenance


    Liquid Gasket
    REMOVAL OF LIQUID GASKET • After removing mounting nuts and bolts, separate the mating surface using the seal cutter [SST: KV10111100] (A) and remove old liquid gasket sealing. CAUTION: Be care ...

    Other materials:

    P158A ECM
    DTC Logic *: Since this DTC is detected when G sensor calibration is incomplete, there is not replacement parts. 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition swit ...

    Rear suspension beam
    Exploded View 1. Rear suspension beam 2. Rear suspension arm bracket : Always replace after every disassembly. : N·m (kg-m, ft-lb) Removal and Installation REMOVAL 1. Remove tires. Refer to WT-7, "Removal and Installation". 2. Drain brake fluid. Refer to BR-12, "Draining& ...

    Driver air bag module
    Exploded View 1. Steering column upper cover 2. Steering column assembly 3. Steering column lower cover 4. Side lid LH 5. TORX bolt 6. Driver air bag module 7. TORX bolt 8. Side lid RH 9. Steering wheel 10. Spiral cable 11. Steering angle sensor 12. Combination switch 13. Stee ...