Oil filter

Removal and Installation REMOVAL 1. Remove engine under cover. 2. Using oil filter wrench [SST: KV10115801] (A), remove oil filter. : Vehicle front CAUTION: • Oil filter is provided with relief ...

Periodical Maintenance Specification

ENGINE OIL CAPACITY (APPROXIMATE) ...

Other materials:

Removal and installation
IPDM E/R Exploded View 1. IPDM E/R cover A 2. IPDM E/R 3. IPDM E/R cover B Removal and Installation IPDM E/R integrated relays are not serviceable parts, and must not be removed from the unit. REMOVAL 1. Remove battery. 2. Press and expand pawls (A) on lateral side of IPDM E/R cover ...

P1650 thermoplunger control unit
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK THERMOPLUNGER CONTROL UNIT POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect thermoplunger control unit harness connector. 3. Check the voltage between thermoplunger control unit harness connector and ground. Is the ...

Front drive shaft
Exploded View LEFT SIDE 1. Circular clip 2. Dust shield 3. Housing assembly 4. Boot band 5. Boot 6. Damper band 7. Dynamic damper 8. Circular clip 9. Joint sub-assembly : Wheel side : Fill NISSAN Genuine grease or equivalent. : Always replace after every disassembly. RIGHT ...