Inspection

INSPECTION AFTER INSTALLATION 1. Check the engine oil level. Refer to LU-8, "Inspection". 2. Start the engine, and check that there is no leakage of engine oil. 3. Stop the engine and wai ...

Periodical Maintenance Specification

ENGINE OIL CAPACITY (APPROXIMATE) ...

Other materials:

Blower motor
Diagnosis Procedure 1.CHECK SYMPTOM Check symptom (A or B). Which symptom is detected? A >> GO TO 2. B >> GO TO 7. 2.CHECK FUSE 1. Turn ignition switch OFF. 2. Check 15A fuses (Nos. 14 and 16, located in fuse block (J/B)]. NOTE: Refer to PG-22, "Fuse, Connector and ...

Hood lock
Exploded View 1. Hood lock control cable assembly 2. Hood lock assembly : Clip : N·m (kg-m, ft-lb) : Body grease Hood lock HOOD LOCK : Removal and Installation REMOVAL 1. Remove front center grille. Refer to EXT-18, "Removal and Installation". 2. Remove crash zone sensor. Ref ...

Engine coolant
Inspection LEVEL • Check that the reservoir tank engine coolant level is within the “MIN” to “MAX” when the engine is cool. A : MAX B : MIN • Adjust the engine coolant level if necessary. LEAKAGE • To check for leakage, apply pressure to the cooling system with the radiator ...