Periodical Maintenance Specification

Engine Lubrication System HR16DE

Other materials:

Push-button ignition switch
Removal and Installation REMOVAL 1. Remove the NATS antenna amp. Refer to SEC-167, "Removal and Installation". 2. Remove the push-button ignition switch. 1. Disengage the push-button ignition switch fixing pawls using minus driver etc. 2. Press the push-button ignition switch to ...

P2765 clutch B speed sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Be careful of the driving speed. 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. > ...

Combination switch output circuit
Diagnosis Procedure 1.CHECK OUTPUT 1 - 5 CIRCUIT FOR OPEN 1. Turn ignition switch OFF. 2. Disconnect BCM and combination switch connectors. 3. Check continuity between BCM harness connector and combination switch harness connector. Does continuity exist? YES >> GO TO 2. NO >> ...