Removal and installation

Road wheel tire assembly Exploded View 1. Tire assembly : N·m (kg-m, ft-lb) Removal and Installation REMOVAL 1. Remove wheel nuts. 2. Remove tire assembly. INSTALLATION Install in the rev ...

Brake System LHD

...

Other materials:

System
Starting system (with intelligent key) : System Diagram *1: M/T models *2: CVT models Starting system (with intelligent key) : System Description CVT MODELS • When selector lever is P or N, power is supplied to starter relay and starter control relay by transmission range switch. And BCM a ...

Hazard switch
Component Function Check 1.CHECK HAZARD SWITCH SIGNAL BY CONSULT-III CONSULT-III DATA MONITOR 1. Turn the ignition switch ON. 2. Select “HAZARD SW” of BCM (FLASHER) data monitor item. 3. With operating the hazard switch, check the monitor status. Is the inspection result normal? YES >> ...

P159A, P159C, P159D G sensor
For M/T models : DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. T ...