Nissan Juke Service and Repair Manual : Seat Belt

Removal and installation
EPS CONTROL UNIT Removal and Installation Never remove EPS control unit from steering column assembly. When replacing EPS control unit, replace steering column assembly. Refer to ST-10, "Rem ...

Other materials:

Rear oil seal
REAR OIL SEAL : Removal and Installation REMOVAL 1. Remove transaxle assembly. Refer to TM-301, "Exploded View" (CVT models) or TM-84, "MR16DDT : Exploded View" (M/T models). 2. Remove clutch cover and clutch disk (M/T models). Refer to CL-29, "EXCEPT FOR K9K : Explo ...

B1001, B1002, B1003, B1004, B1005 diagnosis sensor unit
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning la ...

Models without Intelligent Key system
1. Apply the parking brake. 2. Continuously Variable Transmission (CVT) models: Move the shift lever to the P (Park) or N (Neutral) position. (P is recommended.) The starter is designed so that it does not operate unless the shift lever is in either of the above positions. Manual Transmission ...