Nissan Juke Service and Repair Manual : Removal and installation

EPS CONTROL UNIT

Removal and Installation

Never remove EPS control unit from steering column assembly. When replacing EPS control unit, replace steering column assembly. Refer to ST-10, "Removal and Installation".

    Unbalance steering wheel turning force (torque variation)
    Description Unbalance steering wheel turning force (torque variation). Diagnosis Procedure 1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP Check the EPS warning lamp while engine is running. D ...

    Seat Belt
    ...

    Other materials:

    B1130 side air bag module RH
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...

    Idle neutral control learning
    Description TCM corrects an individual difference in clutch clearance of the transaxle assembly by performing the idle neutral control learning and enables accurate idle neutral control. Therefore, it is required to perform idle neutral control learning after the following work is performed ...

    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
    The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is include ...