Precautions for Drive Shaft

• Observe the following precautions when disassembling and assembling drive shaft. - Never disassemble joint sub-assembly because it is non-overhaul parts. - Perform work in a location which is ...

Special Service Tool

...

Other materials:

Basic inspection
DIAGNOSIS AND REPAIR WORK FLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1.GET INFORMATION FOR SYMPTOM 1. Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred). 2. Check operation condition of the function th ...

ECU diagnosis information
4WD control module Reference Value VALUES ON THE DIAGNOSIS TOOL TERMINAL LAYOUT PHYSICAL VALUES *: The values are changed by throttle opening and engine speed. CAUTION: When using circuit tester to measure voltage for inspection, be sure not to extend forcibly any connector t ...

B26F7 BCM
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Press door request switch. 2. Turn ignition switch ON. 3. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III. Is DTC detected? YES >> Go to SEC-127, "Dia ...