Removal and Installation Procedure for CVT Unit Connector

REMOVAL • Rotate bayonet ring (A) counterclockwise. Pull out CVT unit harness connector (B) upward and remove it. INSTALLATION 1. Align marking (A) on CVT unit harness connector terminal with ...

Special Service Tools

*: The O-ring as an unit part is set as a SST. ...

Other materials:

Remote keyless entry receiver
Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “KEYLESS ” or “KEYLESS UNLOCK” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result norma ...

Passenger side door mirror defogger
Description Heats the heating wire with the power supply from the rear window defogger relay to prevent the door mirror from fogging up. Component Function Check 1.CHECK PASSENGER SIDE DOOR MIRROR DEFOGGER 1. Perform IPDM E/R Active Test (“REAR DEFOGGER”) using CONSULT-III. 2. Touch “O ...

Back door opener system
System Diagram System Descr BACK DOOR OPENER OPERATION When back door opener switch is pressed, BCM operates back door opener actuator. NOTE: Back door opener actuator is not for locking the back door. The function is only to open the back door. OPERATION CONDITION If the following ...