Nissan Juke Service and Repair Manual : Precaution for TCM and Transaxle Assembly Replacement

CAUTION:
• To replace TCM, refer to TM-374, "Description".

• To replace transaxle assembly, refer to TM-375, "Description".

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all contro ...

    Precaution for G Sensor Removal/Installation or Replacement
    CAUTION: To remove/install or replace G sensor, refer to TM-377, "Description". ...

    Other materials:

    P1556, P1557 battery temperature sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. Turn ignition switch OFF and wait at least 10 seconds. TESTING CONDITION: Before performing the following procedure, confirm ...

    How to select piston and bearing
    Description • The identification grade stamped on each part is the grade for the dimension measured in new condition. This grade cannot apply to reused parts. • For reused or repaired parts, measure the dimension accurately. Determine the grade by comparing the measurement with the values o ...

    Mixture ratio self-learning value clear
    Description This describes how to erase the mixture ratio self-learning value. For the actual procedure, follow the instructions in “Diagnosis Procedure”. Work Procedure 1.START With CONSULT-III 1. Start engine and warm it up to normal operating temperature. 2. Select “SELF-LEARNING CONT” i ...