Nissan Juke Service and Repair Manual : Precaution for G Sensor Removal/Installation or Replacement
CAUTION:
To remove/install or replace G sensor, refer to TM-377, "Description".
Precaution for TCM and Transaxle Assembly Replacement
CAUTION:
• To replace TCM, refer to TM-374, "Description".
• To replace transaxle assembly, refer to TM-375, "Description". ...
General Precautions
• Turn ignition switch OFF and disconnect the battery cable
from the negative terminal before connecting or disconnecting
the CVT assembly harness connector. Because battery
voltage is applied to ...
Other materials:
Dynamic driver assistance switch
(for vehicles without ProPILOT Assist)
The physical dynamic driver assistance switch allows the operator to temporarily activate or deactivate the advanced Intelligent Lane Intervention (I-LI) and Intelligent Blind Spot Intervention (I-BSI) safety systems, assuming these safety features have already been enabled wit ...
B1147 curtain air bag module RH
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning la ...
4WD warning lamp does not turn off
Description
4WD warning lamp does not turn OFF several seconds after the engine started.
Diagnosis Procedure
1.PERFORM SELF-DIAGNOSIS
With CONSULT-III
Perform self-diagnosis for “ALL MODE AWD/4WD”.
Is any DTC detected?
YES >> Check the DTC. Refer to DLN-33, "DTC Index".
...
