Nissan Juke Service and Repair Manual : Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

The Supplemental Restraint System such as ???AIR BAG??? and ???SEAT BELT PRE-TENSIONER???, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.

Information necessary to service the system safely is included in the ???SRS AIR BAG??? and ???SEAT BELT??? of this Service Manual.

WARNING:
To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision that would result in air bag inflation, all maintenance must be performed by an authorized NISSAN/INFINITI dealer.

• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see ???SRS AIR BAG???.

• Never use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.

PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS

WARNING:
• When working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with the ignition ON or engine running, never use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury.

• When using air or electric power tools or hammers, always switch the ignition OFF, disconnect the battery, and wait at least 3 minutes before performing any service.

    Precaution for Procedure without Cowl Top Cover
    When performing the procedure after removing cowl top cover, cover the lower end of windshield with urethane, etc. ...

    Other materials:

    Driver air bag module
    Exploded View 1. Steering column upper cover 2. Steering column assembly 3. Steering column lower cover 4. Side lid LH 5. TORX bolt 6. Driver air bag module 7. TORX bolt 8. Side lid RH 9. Steering wheel 10. Spiral cable 11. Steering angle sensor 12. Combination switch 13. Stee ...

    Engine unit
    Disassembly 1. Remove intake manifold. Refer to EM-163, "Exploded View". 2. Remove exhaust manifold. Refer to EM-166, "Exploded View". 3. Remove oil pan (lower). Refer to EM-169, "Exploded View". 4. Remove ignition coil, spark plug, and rocker cover. Refer to EM-17 ...

    DPF (diesel particulate filter) data clear
    Description Perform ???DIESEL PARTICULATE FILTER DATA CLEAR??? in ???WORK SUPPORT??? mode with CONSULT-III when oxidation catalyst with diesel particulate filter is replaced as new one. Based on the signal from sensors ECM estimates the amount of particulate matter in diesel particulate filte ...