How to use this section

Caution • This section describes information peculiar to a vehicle and inspection procedures. • For trouble diagnosis procedure, refer to LAN-17, "Trouble Diagnosis Procedure". Abbrev ...

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passen ...

Other materials:

Inspection
INSPECTION AFTER REMOVAL Appearance Check the propeller shaft for bend and damage. If damage is detected, replace propeller shaft assembly. Propeller Shaft Runout Check propeller shaft runout at measuring points with a dial indicator. If runout exceeds specifications, replace propeller sh ...

Service data and specifications (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS) Idle Speed *: Under the following conditions • A/C switch: OFF • Electric load: OFF (Lights, heater fan & rear window defogger) • Steering wheel: Kept in straight-ahead position Ignition Timing *: Under the following conditions • A/C switch: OFF ...

P2119 electric throttle control actuator
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.PERFORM DTC CONFIRMATION PROCEDURE ...