Nissan Juke Service and Repair Manual : Power Outlet

Removal and installation
HORN Exploded View WITHOUT VEHICLE SECURITY SYSTEM 1. Horn high 2. Horn low 3. Horn bracket WITH VEHICLE SECURITY SYSTEM 1. Horn low 2. Horn bracket Removal and Installation REMOVAL ...

Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, ...

Other materials:

Engine stand setting
Preparing the engine to be on the stand Before the engine is mounted on the engine sub-attachment, the engine's electrical harness must be removed and the engine oil drained. 1. Remove the multifunction support. 2. Remove the coolant inlet pipe on the water pump. 3. Place the rods (A), ...

P0488 EGR system
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK EGR VOLUME CONTROL VALVE CONTROL CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect EGR volume control valve harness connector and ECM harness connector. 3. Check the continuity between EGR volume control valve terminal harness co ...

P0097, P0098 IAT sensor 2
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...