Nissan Juke Service and Repair Manual : Periodic maintenance

CVT FLUID

Inspection

FLUID LEAKAGE

• Check transaxle surrounding area (oil seal and plug etc.)for fluid leakage.

• If anything is found, repair or replace damaged parts and adjust CVT fluid level. Refer to TM-379, "Adjustment".

Removal and installation


    Symptom diagnosis
    CVT CONTROL SYSTEM Symptom Table The diagnosis item number indicates the order of check. Start checking in the order from 1. ...

    Other materials:

    Draining
    1. Run the vehicle to warm up the transfer unit sufficiently. 2. Stop the engine and remove the drain plug (1) and gascket to drain the transfer oil. 3. Before installing drain plug, set a new gasket. Install drain plug on the transfer and tighten to the specified torque. Refer to DLN- 113, &qu ...

    P0420 three way catalyst function
    DTC Logic DTC DETECTION LOGIC The ECM monitors the switching frequency ratio of air fuel ratio (A/F) sensor 1 and heated oxygen sensor 2. A three way catalyst (manifold) with high oxygen storage capacity will indicate a low switching frequency of heated oxygen sensor 2. As oxygen storage c ...

    Indicator lights
    All-Wheel Drive (AWD) indicator light (AWD model) When the ignition switch is in the “ON” position, the All-Wheel Drive (AWD) indicator light illuminates and then turns off. When selecting AWD mode while the engine is running, the AWD indicator light illuminates. (See “All-Wheel Drive (AWD ...