Nissan Juke Service and Repair Manual : Parts To Be Replaced After Removal
• All gaskets
• Flywheel bolts
• Crankshaft bearing bolts
• Camshaft pulley bolt
• Crankshaft pulley bolts
• Big end cap bolts
• Injector holder copper washers
• Fuel injection tubes
• Pipe plugs
• Belts
• Timing belt tension wheel
• Oil jets
• Turbocharger plastic pipes
Precaution for Diesel Equipment
CLEANLINESS
CLEANLINESS INSTRUCTIONS WHICH MUST BE FOLLOWED WHEN WORKING ON THE HIGH
PRESSURE
DIRECT INJECTION SYSTEM
Risks relating to contamination
The system is very sensitive to contaminatio ...
Installation of Thread Inserts
Threaded holes on all engine component parts can be repaired by using thread
inserts. ...
Other materials:
Power supply and ground circuit
PTC HEATER CONTROL UNIT : Diagnosis Procedure
1.CHECK FUSE
1. Turn ignition switch OFF.
2. Check 10A fuses (No. 3 and 7).
NOTE:
Refer to PG-23, "Fuse and Fusible Link Arrangement".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Replace the blown fuse after ...
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver a ...
Rear disc brake
Brake pad : Exploded View
1. Sliding pin bolt
2. Cylinder body
3. Inner shim cover
4. Inner shim
5. Inner pad (with pad wear sensor)
6. Pad retainer
7. Torque member
8. Outer pad
9. Outer shim
10. Outer shim cover
1 Apply rubber grease.
2: Apply MOLYKOTE® AS880N or
silicone-bas ...
