Nissan Juke Service and Repair Manual : Installation of Thread Inserts
Threaded holes on all engine component parts can be repaired by using thread inserts.
Parts To Be Replaced After Removal
• All gaskets
• Flywheel bolts
• Crankshaft bearing bolts
• Camshaft pulley bolt
• Crankshaft pulley bolts
• Big end cap bolts
• Injector holder copper washers
• Fuel injection tubes
• Pipe pl ...
Preparation
...
Other materials:
P1226 TP sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition swit ...
Assembly and Installation
• Use torque wrench to tighten bolts or nuts to specification.
• When tightening nuts and bolts, as a basic rule, equally tighten in several
different steps starting with the
ones in center, then ones on inside and outside diagonally in this order. If the
order of tightening is specified,
do ...
Engine unit
Disassembly
1. Remove intake manifold. Refer to EM-28, "Exploded View".
2. Remove catalyst convertor. Refer to EM-33, "2WD : Exploded View" (2WD models)
or EM-34, "4WD :
Exploded View" (4WD models).
3. Remove turbocharger. Refer to EM-36, "Exploded View" ...