P1205 exhaust fuel injector

DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK EXHAUST FUEL INJECTOR POWER SUPPLY CIRCUIT FOR OPEN AND SHORT 1. Turn ignition switch OFF. 2. Disconnect exhaust fuel injector harness ...

P1544 EGT sensor 2

DTC Logic DTC DETECTION LOGIC NOTE: If DTC P1544 is displayed with DTC P0115, first perform trouble diagnosis for DTC P0115. Refer to EC-907, "DTC Logic". Diagnosis Procedure 1.CHE ...

Other materials:

B2014 chain of STRG-IMMU
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Lock steering. NOTE: 3. Press the push-button ignition switch. 4. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III. Is DTC detected? YES >> Go to SEC-7 ...

Power supply and ground circuit
Diagnosis Procedure 1.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) IGNITION POWER SUPPLY 1. Turn the ignition switch OFF. 2. Disconnect ABS actuator and electric unit (control unit) harness connector. 3. Check voltage between ABS actuator and electric unit (control unit) harness conne ...

P1808 Wheel speed sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE W ...