Nissan Juke Service and Repair Manual : P0606 ECM

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure


Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Erase DTC.

3. Turn ignition switch OFF and wait for 20 seconds.

4. Turn ignition switch ON and perform the self-diagnosis.

Is the DTC P0606 displayed again? YES >> GO TO 2.

NO >> INSPECTION END

2.REPLACE ECM

1. Replace ECM.

2. Go to EC-879, "Work Procedure".

>> INSPECTION END

    P0575 ASCD steering switch
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK ASCD STEERING SWITCH CIRCUIT 1. Check ASCD steering switch circuit. ASCD steering switch>>Refer to EC-1011, "Component Fun ...

    P060A ECM
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.INSPECTION START 1. Turn ignition switch ON. 2. Erase DTC. 3. Turn ignition switch OFF and wait for 20 seconds. 4. Turn ignition switch ON ...

    Other materials:

    Coil spring
    Exploded View 1. Upper rubber seat 2. Coil spring 3. Lower rubber seat 4. Suspension arm : Vehicle front Removal and Installation REMOVAL 1. Remove tires. Refer to WT-7, "Removal and Installation". 2. Remove wheel sensor and sensor harness. Refer to BRC-86, "REAR WHEEL SE ...

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the ...

    Front disc brake
    Brake pad : Exploded View MR16DDT 1. Cylinder body 2. Inner shim 3. Inner pad (with pad wear sensor) 4. Pad retainer 5. Torque member 6. Outer pad 7. Outer shim 1: Apply MOLYKOTE® AS880N or silicone-based grease. 2: Apply MOLYKOTE® 7439 or equivalent. : N·m (kg-m, ft-lb) HR1 ...