Nissan Juke Service and Repair Manual : DTC/circuit diagnosis
- Power supply and ground circuit
- Microphone signal circuit
- Steering switch signal a circuit
- Steering switch signal B circuit
- Steering switch ground circuit
Additional service when removing battery negative terminal
Description
• The audio unit is equipped with the anti-theft system.
• The audio unit operates after authenticating a fixed four-digit anti-theft
code.
• After removing the battery of the audio u ...
Power supply and ground circuit
AUDIO UNIT
AUDIO UNIT : Diagnosis Procedure
1.CHECK FUSE
Check for blown fuses.
Is inspection result OK?
YES >> GO TO 2.
NO >> Be sure to eliminate cause of malfunction before in ...
Other materials:
Consult-III/GST checking system
Description
• When CONSULT-III/GST is connected with a data link connector
(A) equipped on the vehicle side, it will communicate with the control
unit equipped in the vehicle and then enable various kinds of
diagnostic tests.
1 : Instrument lower panel RH
• Refer to CONSULT-III Software Opera ...
P2765 clutch B speed sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
CAUTION:
Be careful of the driving speed.
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition
switch OFF and wait for at
least 10 seconds, then perform the next test.
> ...
Control buttons
The control buttons for the Bluetooth® Hands- Free Phone System are located on
the steering wheel.
PHONE SEND
Push the button to initiate a VR
session or answer an incoming call.
You can also use the button to
interrupt system feedback and give a command at once.
PHONE END
While the ...
