Basic inspection

DIAGNOSIS AND REPAIR WORK FLOW Work Flow DETAILED FLOW 1.OBTAIN INFORMATION ABOUT SYMPTOM Interview the customer to obtain as much malfunction information (conditions and environment when the ma ...

Door mirror remote control switch (mirror switch/ changeover switch)

Component Inspection 1.CHECK MIRROR SWITCH & CHANGEOVER SWITCH 1. Turn ignition switch OFF. 2. Disconnect door mirror remote control switch connector. 3. Check door mirror remote control switc ...

Other materials:

Rear door glass
Exploded View 1. Rear door panel 2. Sealing screen 3. Lower sash (front) 4. Rear door regulator assembly 5. Power window motor 6. Rear door glass 7. Lower sash (rear) 8. Rear door glass run Removal and Installation REMOVAL 1. Fully open rear door glass. 2. Remove rear door finishe ...

C1601 battery power supply
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE W ...

P range interlock door lock/unlock function does not operate
Diagnosis Procedure 1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT” mode. 3. Check “AUTOMATIC LOCK/UNLOCK SELECT” setting in “WORK SUPPORT� ...