Nissan Juke Service and Repair Manual : DPF (diesel particulate filter) data clear

Description

Perform ???DIESEL PARTICULATE FILTER DATA CLEAR??? in ???WORK SUPPORT??? mode with CONSULT-III when oxidation catalyst with diesel particulate filter is replaced as new one. Based on the signal from sensors ECM estimates the amount of particulate matter in diesel particulate filter and stores the value in EEPROM as diesel particulate filter data. When oxidation catalyst with diesel particulate filter is replaced as new one, there is a difference between diesel particulate filter data stored in ECM and the actual amount of particulate matter in diesel particulate filter, because no particulate matter is trapped in new diesel particulate filter. In this case, ECM cannot perform regeneration control correctly. So perform ???DIESEL PARTICULATE FILTER DATA CLEAR??? in ???WORK SUPPORT??? mode with CONSULT-III to clear diesel particulate filter data stored in ECM.

CAUTION:
Never perform ???DIESEL PARTICULATE FILTER DATA CLEAR??? in ???WORK SUPPORT??? mode with CONSULT- III when oxidation catalyst with diesel particulate filter is not replaced as new one. Diesel particulate filter may be damaged because regeneration is not performed at appropriate timing.

Work Procedure

1.START

1. Turn ignition switch ON.

2. Select ???DIESEL PARTICULATE FILTER DATA CLEAR??? in ???WORK SUPPORT??? mode with CONSULT-III.

3. Touch ???CLEAR??? and wait a few seconds.

4. Make sure that ???CMPLT??? is displayed on CONSULT-III screen.

>> END

    Service regeneration
    Description Service Regeneration is performed with CONSULT-III to reduce particulate matter in diesel particulate filter. Service Regeneration should be performed in the following cases. • EC ...

    Other materials:

    Diagnosis Procedure
    WARNING: • Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait at least 3 minutes. (To discharge backup capacitor.) • Never use unspecified tester or other measuring device. 1.CHECK HARNESS CONNECTOR Check the harness connector. Is the inspection ...

    System
    4WD system : System Diagram INPUT/OUTPUT SIGNAL It transmits/receives each signal from the following 4WD control module via CAN communication line. 4WD system : System Description • 4WD mode is selectable among 2WD, 4WD-V, and 4WD by operating the 4WD mode switch. • When judging d ...

    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
    The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is ...