Nissan Juke Owners Manual : Corrosion protection
- Most common factors contributing to vehicle corrosion
- Environmental factors influence the rate of corrosion
- To protect your vehicle from corrosion
Seat belts
The seat belts can be cleaned by wiping them with a sponge dampened in a mild
soap solution. Allow the belts to dry completely in the shade before using them.
See “Seat belts” .
WARNING
Do not al ...
Most common factors contributing to vehicle corrosion
• The accumulation of moisture-retaining dirt and debris in body panel sections,
cavities, and other areas.
• Damage to paint and other protective coatings caused by gravel and stone chips
or min ...
Other materials:
B1115 satellite sensor RH
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
System
Warning chime system
WARNING CHIME SYSTEM : System Diagram
WARNING CHIME SYSTEM : System Description
COMBINATION METER
The combination meter sounds the alarm buzzer installed in the combination
meter when receiving the buzzer
output signal transmitted from each unit.
BCM
BCM receives si ...
Output speed sensor
Exploded View
1. Transaxle assembly
2. Output speed sensor
3. O-ring
: Vehicle front
: Always replace after every
disassembly.
: N·m (kg-m, in-lb)
: Genuine NISSAN CVT Fluid NS-2
Removal and Installation
REMOVAL
1. Disconnect battery cable from negative terminal. Refer to PG-124, &qu ...
