Nissan Juke Owners Manual : Continuously Variable Transmission (CVT)
All-Wheel Drive (AWD) models:
Do not tow an AWD vehicle with any of the wheels on the ground.
Two-Wheel Drive (2WD) models:
To tow a vehicle equipped with a Continuously Variable Transmission (CVT), an appropriate vehicle dolly MUST be placed under the towed vehicle’s driving wheels. Always follow the dolly manufacturer’s recommendations when using their product.
Flat towing
Towing your vehicle with all four wheels on the ground is sometimes called flat
towing. This method is sometimes used when towing a vehicle behind a recreational
vehicle, such as a motor home.
CA ...
Manual Transmission
• Always tow with the manual transmission in Neutral.
• Your vehicle speed should never exceed 70 MPH (112 km/h) when flat towing your
vehicle.
• After towing 500 miles (805 km), start and idle th ...
Other materials:
P2765 clutch B speed sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
CAUTION:
Be careful of the driving speed.
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition
switch OFF and wait for at
least 10 seconds, then perform the next test.
> ...
B27A6, B27A7, B27A8, B27A9 mode door motor
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC is displayed along with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to HAC-
51, "DTC Logic".
• If DTC is displayed along with DTC U1010, first perform the trouble diagnosis
for DTC U1010. HAC-52,
"DTC Logic ...
Front wiper auto stop signal circuit
Component Function Check
1.CHECK FRONT WIPER (AUTO STOP) SIGNAL
CONSULT-III DATA MONITOR
1. Select “WIP AUTO STOP” of IPDM E/R data monitor item.
2. Operate the front wiper.
3. With the front wiper operation, check the monitor status.
Is the status of item normal?
YES >> Auto stop sig ...
