Nissan Juke Owners Manual : CD/USB memory care and cleaning

CD


CD

• Handle a CD by its edges. Never touch the surface of the disc. Do not bend the disc.

•  Always place the discs in the storage case when they are not being used.

• To clean a disc, wipe the surface from the center to the outer edge using a clean, soft cloth. Do not wipe the disc using a circular motion. Do not use a conventional record cleaner or alcohol intended for industrial use.

• A new disc may be rough on the inner and outer edges. Remove the rough edges by rubbing the inner and outer edges with the side of a pen or pencil as illustrated.

USB memory

• Do not touch the terminal portion of the USB memory.

•  Do not place heavy objects on the USB memory.

•  Do not store the USB memory in very humid locations.

• Do not expose the USB memory to direct sunlight.

• Do not spill any liquids on the USB memory.

Refer to the USB memory Owner’s Manual for the details.

    FM-AM-SAT radio with Compact Disc (CD) player (Type B)
    1. XM band select button 2. CD insert slot 3. CD EJECT button 4. TUNE/SCROLL knob and AUDIO control button 5. Radio station preset buttons 6. AUX button 7. ON·OFF button/VOLUME control knob 8 ...

    Steering wheel switch for audio control
    1. SOURCE select switch 2. Tuning switch 3. VOLUME control switch The audio system can be operated using the controls on the steering wheel. SOURCE select switch Push the SOURCE select switch t ...

    Other materials:

    P183D side G sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...

    Intelligent Key battery discharge
    If the battery of the Intelligent Key is discharged, or environmental conditions interfere with the Intelligent Key operation, start the engine according to the following procedure: 1. Move the shift lever to the P (Park) position (for Continuously Variable Transmission models) or the shift ...

    Unit removal and installation
    Transaxle assembly Exploded View 1. Transaxle assembly : Refer to "INSTALLATION" in TM-30, "Removal and Installation" for the locations and tightening torque. Removal and Installation CAUTION: Never reuse CSC (Concentric Slave Cylinder). Because CSC slides back to the ...