Nissan Juke Service and Repair Manual : Battery terminal with fusible link

Exploded View

1 : Battery terminal with fusible link 2 : Harness connector

: N·m (kg-m, ft-lb)


Removal and Installation


Removal and Installation

REMOVAL

1. Disconnect the battery cable from the negative terminal.

2. Remove cover of battery positive terminal.

3. Remove harness mounting nut and battery terminal with fusible link mounting nut.

4. Disconnect harness connector and remove battery terminal with fusible link.

INSTALLATION

Install in the reverse order of removal.

    Battery
    Exploded View 1 : Battery fix frame :N·m (kg-m, in-lb) Removal and Installation REMOVAL 1. Disconnect the battery cable from the negative terminal. CAUTION: When disconnecting, disconnect ...

    Other materials:

    Service Notice or Precautions for Manual Transaxle
    CAUTION: • Never reuse CSC (Concentric Slave Cylinder). Because CSC slides back to the original position every time when removing transaxle assembly. At this timing, dust on the sliding parts may damage a seal of CSC and may cause clutch fluid leakage. Refer to CL-27, "Removal and In ...

    Installing front license plate
    Use the following steps to mount the license plate: Before mounting the license plate, confirm that the following parts are enclosed in the plastic bag. •  License plate bracket •  J-nut  2 •  Screw  2 • Screw grommet  2 1. Park the vehicle on flat, ...

    P0031, P0032 A/F sensor 1 heater
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...