Nissan Juke Service and Repair Manual : Unit removal and installation
Clutch piping
Exploded View RS5F92R 1. CSC (Concentric Slave Cylinder) 2. Clutch tube 3. Clutch damper 4. Bracket 5. Master cylinder RS6F94R 1. CSC (Concentric Slave Cylinder) 2. Clutch tube 3. C ...CSC (concentric slave cylinder)
Exploded View 1. Transaxle assembly 2. CSC (Concentric Slave Cylinder) : Always replace after every disassembly. : N·m (kg-m, ft-lb) Removal and Installation CAUTION: • Never reuse CSC (Co ...Other materials:
P0031, P0032 A/F sensor 1 heater
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn
ignition switch OFF and wait wait
at least 10 seconds before conducting the next test.
TESTING CONDITION:
Before performing the following p ...
Exterior and interior lights
: See a NISSAN dealer for replacement.
NOTE: Always check with the Parts Department at a NISSAN dealer for the latest
information about parts.
: REMOVE
: INSTALL
Replacement procedures
All other lights are either type A, B, C, D or E.
When replacing a bulb, first remove the lens and/or c ...
Blower fan on signal
Component Function Check
1.CHECK BLOWER FAN ON SIGNAL
With CONSULT-III
1. Turn ignition switch ON.
2. Select “AIR CONDITIONER” of “BCM” using CONSULT-III.
3. Select “FAN ON SIG” in “DATA MONITOR” mode, and check status under the
following condition.
Is the inspection result normal?
YES &g ...