Nissan Juke Service and Repair Manual : Instrument Panel

Other materials:

General Precautions
Always use a 12 volt battery as power source. Do not attempt to disconnect battery cables while engine is running. Before connecting or disconnecting the ECM harness connector, turn ignition switch OFF, wait 3 minutes and disconnect battery negative cable. Failure to do so may damage the ...

ECU diagnosis information
ABS actuator and electric unit (control unit) Reference Value CONSULT-III DATA MONITOR STANDARD VALUE *1: Confirm tire pressure is standard value. *2: Refer to valve operation in BRC-105, "System Description" for valve operation of each valve. *3: Refer to BRC-105, "Sys ...

Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE: Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. Always use CONS ...