Nissan Juke Service and Repair Manual : U1010 control unit (can)

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure


Diagnosis Procedure

1.REPLACE BCM

When DTC “U1010” is detected, replace BCM.

>> Replace BCM. Refer to BCS-161, "Removal and Installation".

    U1000 can comm
    Description CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-vehicle multiplex communication line with high data communication speed and excelle ...

    Power supply and ground circuit
    Diagnosis Procedure 1.CHECK FUSES AND FUSIBLE LINK Check that the following fuses and fusible link are not fusing. Is the fuse fusing? YES >> Replace the blown fuse or fusible link after r ...

    Other materials:

    Rear bumper
    Exploded View 1. Bumper side bracket LH 2. Bumper closing LH 3. Bumper fascia assembly 4. Reflex reflector LH 5. Rear panel lower 6. U nut 7. Bumper fascia lower 8. Reflex reflector RH 9. Bumper stay LH 10. screw grommet 11. Bumper energy absorber 12. Bumper stay RH 13. Bumper ...

    Service data and specifications (SDS)
    Wheel Bearing Drive Shaft 2WD *: For measuring position, refer to FAX-26, "WHEEL SIDE : Disassembly and Assembly" (Wheel side), FAX- 29, "TRANSAXLE SIDE : Disassembly and Assembly" (Transaxle side). 4WD *: For measuring position, refer to FAX-26, "WHEEL SIDE : ...

    MR16DDT : Exploded View
    REMOVAL 1. “S” terminal harness 2. “B” terminal harness 3. Starter motor 4. Cylinder block : Vehicle front : N·m (kg-m, in-lb) : N·m (kg-m, ft-lb) DISASSEMBLY Type: S114-902 1. Magnetic switch assembly 2. Dust cover kit 3. Shift lever set 4. Center bracket (A) 5. Yok ...