Preparation

Engine Cooling System

Other materials:

P0840 transmission fluid pressure SEN/SW A
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repair, perform the following procedure to confirm the mal ...

Exploded View
1. Final drive mounting bracket 2. Washer 3. Rear final drive assembly : Vehicle front : N·m (kg-m, ft-lb) : Never reuse parts : Apply multi purpose grease : Apply gear oil. ...

Front wheel hub and knuckle
Inspection COMPONENT PART Check that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal. WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE) Check the following items, and replace the part if necessary. • Move wheel hub assembly in ...