Precautions for Harness Repair

• Solder the repaired area and wrap tape around the soldered area. NOTE: A fray of twisted lines must be within 110 mm (4.33 in). • Bypass connection is never allowed at the repaired area. ...

Component parts

Component Parts Location LHD MODELS 1. Multi display unit 2. ABS actuator and electric unit (control unit) 3. A/C auto amp. (With auto air conditioning) PTC heater control unit (Diesel engine ...

Other materials:

B1145 curtain air bag module RH
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning la ...

Differential side oil seal
Exploded View 1. Transaxle assembly 2. Differential side oil seal (left side) 3. Differential side oil seal (right side) : Vehicle front : Always replace after every disassembly. : Genuine NISSAN CVT Fluid NS-2 Removal and Installation REMOVAL NOTE: Cap or plug openings to prevent flui ...

Fillet molding
Exploded View 1. Grommet 2. Clip 3. Clip 4. Front fillet molding 5. Rear fillet molding : Pawl : Do not reuse Front fillet molding FRONT FILLET MOLDING : Removal and Installation REMOVAL 1. Remove front fillet molding fixing clips. 2. Remove front fillet molding front side fixing pa ...