Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, ...

Component parts

Component Part Location 1. BCM Refer to BCS-161, "Removal and Installation". 2. Heater control 3. Blower fan resistor 4. Blower motor A. Left side of heater unit assembly B. Right ...

Other materials:

P160C ECM
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.INSPECTION START 1. Turn ignition switch ON. 2. Erase DTC. 3. Turn ignition switch OFF and wait for 20 seconds. 4. Turn ignition switch ON and perform the self-diagnosis. Is the DTC P160C displayed again? YES >> GO TO 2. NO &g ...

Power supply and ground circuit
Diagnosis Procedure 1.CHECK FUSES AND FUSIBLE LINK Check that the following IPDM E/R fuses or fusible links are not blown. Is the fuse fusing? YES >> Replace the blown fuse or fusible link after repairing the affected circuit if a fuse or fusible link is blown. NO >> GO TO 2. ...

P0201, P0202, P0203, P0204 fuel injector
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...