Nissan Juke Owners Manual : Self-adjusting brakes

Your vehicle is equipped with self-adjusting brakes.

The disc-type brakes self-adjust every time the brake pedal is applied.

WARNING

See a NISSAN dealer for a brake system check if the brake pedal height does not return to normal.

    Brakes
    If the brakes do not operate properly, have the brakes checked by a NISSAN dealer. ...

    Brake pad wear warning
    The disc brake pads have audible wear warnings. When a brake pad requires replacement, it will make a high pitched scraping sound when the vehicle is in motion. This scraping sound will first occur ...

    Other materials:

    Clutch pedal position switch
    Component Function Check 1.CHECK FOR CLUTCH PEDAL POSITION SWITCH FUNCTION 1. Turn ignition switch ON. 2. Check the voltage between ECM harness connector and ground. Is the inspection result normal? YES >> INSPECTION END. NO >> Proceed to EC-427, "Diagnosis Procedure" ...

    Readiness for Inspection/Maintenance (I/M) test
    WARNING A vehicle equipped with All-Wheel Drive (AWD) should never be tested using a two wheel dynamometer (such as the dynamometers used by some states for emissions testing), or similar equipment. Make sure you inform test facility personnel that your vehicle is equipped with AWD before it ...

    C1604 torque sensor
    DTC Logic DTC DETECTION LOGI DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With C ...