Nissan Juke Service and Repair Manual : Removal and installation

Front drive shaft
Inspection Check the following items, and replace the part if necessary. • Check drive shaft mounting point and joint for looseness and other damage. CAUTION: Replace entire drive shaft assemb ...

Front wheel hub and knuckle
Exploded View 1. Steering knuckle 2. Splash guard 3. Hub bolt 4. Wheel hub assembly (Bearing-integrated type) 5. Disc rotor 6. Wheel hub lock nut 7. Adjusting cap 8. Cotter pin A. Tigh ...

Other materials:

P2100, P2103 throttle control motor relay
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. TESTING CONDITION: Before performing the following proced ...

Secondary speed sensor
Exploded View 1. Transaxle assembly 2. O-ring 3. Secondary speed sensor : Vehicle front : Always replace after every disassembly. : N·m (kg-m, in-lb) : Genuine NISSAN CVT Fluid NS-2 Removal and Installation REMOVAL 1. Disconnect battery cable from negative terminal. Refer to PG-124, ...

Removal and Installation
CAUTION: • Be sure to use genuine exhaust system parts or equivalents which are specially designed for heat resistance, corrosion resistance and shape. • Perform the operation with the exhaust system fully cooled down because the system is still hot just after the engine stops. • Be careful ...