Nissan Juke Service and Repair Manual : Removal and Installation

CAUTION:
• Be sure to use genuine exhaust system parts or equivalents which are specially designed for heat resistance, corrosion resistance, and shape.

• Perform the operation with the exhaust system fully cooled down because the system will be hot just after engine stops.

• Be careful not to cut your hand on the heat insulator edge.

    Other materials:

    LAN System can system (type 9)
    DTC/CIRCUIT DIAGNOSIS Main line between IPDM-E and DLC circuit Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (connector s ...

    Push-button ignition switch (models with Intelligent Key system)
    WARNING Do not operate the push-button ignition switch while driving the vehicle except in an emergency. (The engine will stop when the ignition switch is pushed 3 consecutive times or the ignition switch is pushed and held for more than 2 seconds.) If the engine stops while the vehicle is be ...

    Additional service when replacing TCM
    Description Always perform the following items when the TCM is replaced. CHECK LOADING OF CALIBRATION DATA • The TCM acquires calibration data (individual characteristic value) of each solenoid that is stored in the ROM assembly (in the control valve). This enables the TCM to perform accurat ...