Fuel filter

Exploded View Removal and Installation REMOVAL (RHD) 1. Remove quick connectors in the following procedures. • Pinch quick connector square-parts with your fingers, and pull out the quick ...

Fuel level sensor unit

Exploded View 1. Lock ring 2. Fuel level sensor unit 3. Seal packing A. To fuel tank : Always replace after every disassembly Removal and Installation WARNING: Read “General Precaution ...

Other materials:

P1220 fuel pump control module (FPCM)
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. Turn ignition switch OFF and wait at least 10 seconds. TESTING CONDITION: • Before performing the following procedure, con ...

Inside mirror
Adjust the angle of the inside mirror to the desired position. The night position1 will reduce glare from the headlights of vehicles behind you at night. Use the day position2 when driving in daylight hours. WARNING Use the night position only when necessary, because it reduces rear view c ...

Luggage room lamp
Exploded View 1. Bulb housing 2. Bulb 3. Lens : Pawl Removal and Installation CAUTION: Disconnect the battery cable from negative terminal or remove the fuse. REMOVAL 1. Insert a remover tool (A) into the gap between luggage room lamp and luggage side lower finisher RH. 2. Disengage l ...