Replacing

Replace the wiper blades if they are worn. Before replacing the wiper blades, the wiper should be in the fully up position to avoid scratching the engine hood or damaging the wiper arm. To pull u ...

Brakes

If the brakes do not operate properly, have the brakes checked by a NISSAN dealer. ...

Other materials:

System
System Description SYSTEM DIAGRAM • The multi display unit transmits the operation status of the drive mode switch to other units via CAN communication as the mode signal (refer below). - NORMAL: ON/OFF - SPORT: ON/OFF - ECO: ON/OFF • Based on the mode signals received from TCM (CVT mod ...

C1166, C1167 SV system
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT ...

Side turn signal lamp
Exploded View 1. Side turn signal lamp bulb 2. Side turn signal lamp hous Removal and Installation CAUTION: Disconnect battery negative terminal or remove the fuse. REMOVAL 1. Remove the side turn signal lamp in numerical order shown in the figure. 2. Rotate the bulb socket counterclockw ...