Nissan Juke Service and Repair Manual : Propeller Shaft Runout

Journal Axial Play


    Other materials:

    P0730 incorrect gear ratio
    Description TCM selects the gear ratio using the engine load (throttle position), the primary pulley revolution speed, and the secondary pulley revolution speed as input signal. Then it changes the operating pressure of the primary pulley and the secondary pulley and changes the groove width ...

    P1701 TCM
    Description When the power supply to the TCM is cut OFF, for example because the battery is removed, and the self-diagnosis memory function stops, malfunction is detected. NOTE: Since “P1701” will be indicated when replacing TCM, perform diagnosis after erasing “SELF-DIAG RESULTS” DTC Lo ...

    Removal and Installation
    REMOVAL • Disconnect each joint and mounting. • Remove heated oxygen sensor 2 with following procedure: - Using heated oxygen sensor wrench [SST: KV10114400] (A), removal heated oxygen sensor 2 (1). CAUTION: Be careful not to damage heated oxygen sensor 2. INSTALLATION Note the following ...