Precaution Necessary for Steering Wheel Rotation after Battery Disconnect

NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all co ...

System description

DESCRIPTION ...

Other materials:

Basic inspection
Diagnosis and repair work flow Work Flow DETAILED FLOW 1.INTERVIEW FROM THE CUSTOMER Clarify customer complaints before inspection. First of all, perform an interview utilizing BRC-34, "Diagnostic Work Sheet" and reproduce the symptom as well as fully understand it. Ask customer a ...

B1186, B1187, B1188, B1189, B1190, B1191 diagnosis sensor unit
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning la ...

Drive belt
1. Alternator 2. Drive belt auto-tensioner 3. Crankshaft pulley 4. Air conditioner compressor 5. Water pump WARNING Be sure the ignition switch is in the OFF or LOCK position before servicing drive belts. The engine could rotate unexpectedly. 1. Visually inspect the belt for signs of unus ...