Precaution for Procedure without Cowl Top Cover

When performing the procedure after removing cowl top cover, cover the lower end of windshield with urethane, etc. ...

Symptom diagnosis

Squeak and rattle trouble diagnoses Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet ...

Other materials:

How to enable/disable the Steering Assist
Steering-wheel mounted control (right): Used for ProPILOT Assist settings and menu navigation. Vehicle information display: The digital hub for viewing driver assistance settings. Steering Assist switch: The physical toggle located on the instrument ...

C1115 wheel sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CON ...

Service
• Never use electrical test equipment to check SRS circuits unless instructed to in this Service Manual. • Before servicing the SRS, turn ignition switch OFF, disconnect battery negative terminal and wait at least 3 minutes. For approximately 3 minutes after the battery negative termina ...