Nissan Juke Service and Repair Manual : Precaution

Precautions for Suspension

• When installing rubber bushings, the final tightening must be carried out under unladen conditions with tires on ground. Spilled oil might shorten the life of rubber bushings. Be sure to wipe off any spilled oil.

- Unladen conditions mean that fuel, engine coolant and lubricant are full. Spare tire, jack, hand tools and mats are in designated positions.

• After servicing suspension parts, be sure to check wheel alignment.

• Self-lock nuts are not reusable. Always use new ones when installing. Since new self-lock nuts are pre-oiled, tighten as they are.

    Symptom diagnosis
    NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. ×: Applicable ...

    Other materials:

    Removal and installation
    POWER WINDOW MAIN SWITCH Removal and Installation REMOVAL 1. Remove power window main switch finisher. Refer to INT-13, "Removal and Installation". 2. Remove power window main switch (1) from power window main switch finisher (2) using flat-head screw driver (A). : Pawl CAUTION: ...

    P17Ba primary pressure solenoid
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.CHECK DTC DETECTION 1. S ...

    Periodic maintenance
    GEAR OIL Inspection OIL LEAKAGE Make sure that gear oil is not leaking from transaxle or around it. OIL LEVEL 1. Remove filler plug (1) and gasket from transaxle case. 2. Check the oil level from filler plug mounting hole as shown in the figure. CAUTION: Never start engine while checkin ...