Symptom diagnosis

NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. If necessary, repair or replace these parts. ×: Applic ...

Brake pedal

Inspection and Adjustment INSPECTION Brake Pedal Height Check the height (H1) between the dash lower panel (1) and the brake pedal upper surface. H1 : Refer to BR-70, "Brake Pedal". CA ...

Other materials:

Front door lock
Exploded View 1. Door key cylinder assembly (driver side) Outside handle escutcheon (passenger side) 2. Outside handle 3. Front gasket 4. Inside handle 5. TORX bolt 6. Door lock assembly 7. Key rod (driver side) 8. Outside handle bracket 9. Rear gasket 10. Key rod protector (driv ...

Vacuum lines
MR16DDT : Removal and Installation REMOVAL 1. Remove the vacuum hose and vacuum piping. 2. Perform inspection after removal. Refer to BR-115, "MR16DDT : Inspection". INSTALLATION Note the following, install the vacuum hose. • When installing vacuum hose, insert it until its tip r ...

C1115 wheel sensor
DTC Logic DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT-III. 1. Stat the en ...