Symptom diagn

NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. ×: Applicable ...

Front suspension assembly

Inspection COMPONENT PART Check the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal. BALL JOINT AXIAL END PLAY 1. Set front whee ...

Other materials:

BCM (body control module)
Removal and Installation CAUTION: Before replacing BCM, perform “READ CONFIGURATION” to save or print current vehicle specification. Refer to BCS-150, "Description". REMOVAL (RHD MODELS) 1. Remove glove box assembly. Refer to IP-13, "Removal and Installation". 2. Remove ...

Low pressure fuel pump
M/T models : Component Function Check 1.CHECK FUEL PUMP FUNCTION 1. Turn ignition switch ON. 2. Pinch fuel feed hose with two fingers. NOTE: Fuel pressure pulsation should be felt on the fuel feed hose for 1 second after ignition switch is turned ON. Is the inspection result normal? YES ...

P0075 IVT control solenoid valve
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO2. 2.PERFORM DTC CONFIRMATION PROCEDURE ...