Nissan Juke Service and Repair Manual : Front suspension assembly

Inspection

COMPONENT PART

Check the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal.

BALL JOINT AXIAL END PLAY

1. Set front wheels in a straight-ahead position.

2. Measure axial end play by prying it up/down with iron bar or equivalent between transverse link and steering knuckle.

Axial end play : Refer to FSU-22, "Ball Joint".

CAUTION:
• Never depress brake pedal when measuring.

• Never perform with tires on level ground.

• Be careful not to damage ball joint boot. Never damage the installation position by applying excessive force.

STRUT ASSEMBLY

Check for oil leakage, damage, and replace if necessary.

    Wheel alignment
    Inspection DESCRIPTION CAUTION: • The adjustment mechanisms of camber, caster, and kingpin inclination angles are not included. • If camber, caster, or kingpin inclination angle is outside t ...

    Other materials:

    Back door opener switch
    Component Function Check 1.CHECK FUNCTION 1. Select “TRUNK” of “BCM” using CONSULT-III. 2. Select “TR/BD OPEN SW” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Back d ...

    B2602 shift position
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2602 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B2602 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-84, &qu ...

    B26F1 ignition relay
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON under the following conditions, and wait for 2 seconds or more. CVT models - Selector lever is in the P or N position - Do not depress brake pedal M/T models - Do n ...