Nissan Juke Service and Repair Manual : Insufficient heating

Description

Symptom
• Insufficient heating
• No warm air comes out. (Air flow volume is normal.)

Diagnosis Procedure

NOTE

:
Perform self-diagnosis with CONSULT-III before performing symptom diagnosis. If any malfunction result or DTC is detected, perform the corresponding diagnosis.

1.CHECK COOLING SYSTEM

1. Check engine coolant level and check for leakage. Refer to CO-37, "Inspection".

2. Check radiator cap. Refer to CO-40, "RADIATOR CAP : Inspection".

3. Check water flow sounds of the engine coolant. Refer to CO-38, "Refilling".

Is the inspection result normal? YES >> GO TO 2.

NO >> Refill engine coolant and repair or replace parts depending on the inspection results.

2.CHECK HEATER HOSE

Check installation of heater hose by visually or touching.

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace parts depending on the inspection results.

3.CHECK HEATER CORE

1. Check temperature of inlet hose and outlet hose of heater core.

2. Check that inlet side of heater core is hot and the outlet side is slightly lower than/almost equal to the inlet side.

CAUTION:
Always perform the temperature inspection in a short period of time because the engine coolant temperature is very hot.

Is the inspection result normal? YES >> GO TO 4.

NO >> Replace heater core. Refer to HA-56, "HEATER CORE : Removal and Installation".

4.CHECK AIR LEAKAGE FROM EACH DUCT

Check duct and nozzle, etc. of air conditioning system for air leakage.

Is the inspection result normal? YES >> Check air mix door cable installation and air mix door operation.

NO >> Repair or replace parts depending on the inspection results.

    Manual heater system
    Symptom Table NOTE: Perform self-diagnosis with CONSULT-III before performing the symptom diagnosis. If any malfunction result or DTC is detected, perform the corresponding diagnosis. ...

    Other materials:

    ECM branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the ECM for damage, bend and loose connection (unit side and connector side). Is the inspection result normal? YES &g ...

    B2623 inside antenna
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “INSIDE ANT DIAGNOSIS” in “WORK SUPPORT” mode. 3. Perform inside key antenna (“INSIDE ANT DIAGNOSIS”) on “WORK S ...

    NISSAN Advanced Air Bag System (front seats)
    Crash zone sensor Supplemental front-impact air bag modules Front seat-mounted side-impact supplemental air bag modules Occupant classification sensor (weight sensor) Occupant classification system control unit Roof-mounted ...