Nissan Juke Service and Repair Manual : G sensor calibration

Description

TCM stores calibration data (inherent characteristic value) of G sensor to provide accurate control. Therefore, it is required to perform calibration of G sensor after the following work is performed.

• Removal/installation or replacement of G sensor • Replacement of TCM

Procedure

1.PREPARATION BEFORE CALIBRATION PROCEDURE

1. Park the vehicle on a level surface.

2. Adjust air pressure of all tires to the specified pressure. WT-9, "Tire Air Pressure".

>> GO TO 2.

2.PERFORM CALIBRATION

1. Turn ignition switch ON.With CONSULT-III


1. Turn ignition switch ON.

CAUTION:
Never start engine.

2. Select “Work Support” in “TRANSMISSION”.

3. Select “G SENSOR CALIBRATION”.

4. Touch “Start”.

CAUTION:
Never swing the vehicle during “G sensor calibration”.

Is “COMPLETED” displayed? YES >> GO TO 3.

NO >> Perform steps 1 and 2 again.

3.PERFORM THE SELF-DIAGNOSIS

1. Turn ignition switch OFF and wait for 10 seconds.With CONSULT-III


1. Turn ignition switch OFF and wait for 10 seconds.

2. Turn ignition switch ON.

3. Select “Self Diagnostic Results” in “TRANSMISSION”.

Is “P1586” or “P1588” detected? YES >> Go to TM-366, "DTC Index".

NO >> Calibration end

    Additional service when replacing transaxle assembly
    Description Perform the following work after the transaxle assembly is replaced. Erasing the calibration data • The TCM acquires calibration data (individual characteristic value) of each sol ...

    CVT fluid
    Replacement CVT fluid : Refer to TM-512, "General Specification". Fluid capacity : Refer to TM-512, "General Specificatio CAUTION: • Use only Genuine NISSAN CVT Fluid NS-2. Using ...

    Other materials:

    P1226 TP sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. TESTING CONDITION: Before performing the following proced ...

    Diagnosis system (BCM)
    Common item COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the ...

    P047A exhaust gas pressure sensor 2
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P047A is displayed with DTC P0651, first perform trouble diagnosis for DTC P0651. Refer to EC-975, "DTC Logic". Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF and wait at least 20 seconds. 2. Check ground co ...